An economical and pleasant mint scented disinfectant for use in Hydrobaths. Use regularly to flush through the pipe work of the Hydrobath to ensure it stays clean and disinfected. This Flush Cleaner can also be safely used as a general disinfectant, chart for directions of use and dilution rates are provided on the label. Warning – NEVER put the solution into the sealed RINSE tank. Daily Cleaning – We recommend cleaning your hydrobath at the end of every work day. Put 1 capful (or half pump if using a dispenser ) of flush cleaner into the WASH tank, add some water, switch on wash and allow the solution to flush through the pipes. When finished drain the solution then flush through with clean water., Weekly Cleaning – To prevent bad odours we recommend a weekly deep clean by leaving the solution in the Hydrobath overnight. Put one capful (or half pump if using a dispenser ) of flush cleaner in the wash tank and add water from the rinse tank. Then circulate the wash tank as normal as if using shampoo. Do this for approximately two minutes. Turn the wash / rinse lever into the middle position to lock solution inside hose. Open the drain lever to allow three quarters of the solution to drain away and then close the drain lever leaving one quarter in the wash tank. Leave this solution in the bath overnight. In the morning, open the drain and flush the remaining solution through the system with clean water from the rinse tank.
