StripPaint 9900 - Cured Coating Stripper for Powder, E-coating, and Wet Coatings

StripPaint 9900 is a strong paint stripper and remover chemical specially formulated for cured coatings.  Safe for use on multiple surfaces, including aluminum, zinc, magnesium, brass, stainless steel and steel substrates.  This heavy-duty coating stripper removes powder coating, ecoating, and wet-applied coatings.Can StripPaint 9900 be reused?Yes! StripPaint 9900 is designed to be used for multiple bath cycles. Bath life will depend on 3 factors. First how often the bath is used, secondly on the number of parts you run through the bath and the most important factor, how well the bath is maintained. You should get numerous cycles with Strippaint 9900. Any time you replace volume lost through evaporation, carry out and the stripping process you should replace the volume with 80% water and 20% chemical. So for every 5 gallons of lost volume you should replace it with 1 gallon of 9900 and 4 gallons of water. If you maintain this maintenance schedule you will get numerous cycles from this bath. If you can filter out solids that will help as well.RECOMMENDED APPLICATION:Use requires an immersion tank. Ensure there is proper ventilation and that industry standard practices are followed at all times. Immerse parts to be stripped in a solution of 50% StripPaint 9900 and 50% water. Heat tank to 185F for 20 - 60 minutes. Use pressure washer to rinse parts with clean water. BEST TANK MATERIAL: Stainless SteelClick Here to View Technical Data Sheet